![]() Some restrictions applies to CC3D/CC as it needs a compatible input method to enable PWMSync. This is a recommended upgrade for everyone and the more skilled of a pilot you are, the more you will love this release.Ī key improvement that helped achieve this was the addition of the PWMSync code path, this is now enabled by default. In our testing, we have found this to be not only the best flight performance so far in the OpenPilot project but the best flight performance of any project we have tested against. Many enhancements have been made to reducing dead-time of the communication between the flight controller and ESCs. This release introduces major flight performance improvements, enhancements as well as bug fixes. * - CC3D : PWM: Does not go into failsafe when RX is pulled under 50% throttle Release Notes - OpenPilot - Version RELEASE-15.02.1 This release fixes an in important bug that may prevent failsafe to work correctly using CC3D/CC with a PWM receiver. * - due to oneshot higher pid values ki now shows "red" warning in stabilization page * - PPM on Flexi does not work on CC/CC3D * - Version ID wrong in Windows uninstaller * - Tricopter tail servo wrong speed on wizard The full list of bugfixes in this release is accessible here: Release Notes - OpenPilot - Version RELEASE-15.02.02 ![]() This release fixes a bug that prevents revo onboard mag to work correctly. To find the latest release for the CC3D, please see Release – 15.02.02 below. Please note that CC3D is NOT supported by this release.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |